新闻信息
当前位置:首页>新闻信息>新闻信息

低碳钢激光切割,工件毛刺产生的原因

网址:www.  2021-05-15  作者:admin    阅读:

低碳钢激光切割,工件毛刺产生的原因
Reasons for Burr on Workpiece in Laser Cutting of Low Carbon Steel
根据光纤激光切割机的工作原理和规划原则,通过对以下原因的分析,得出了以下原因:
According to the operation and planning principle of optical fiber laser cutting machine, the following reasons are analyzed:
1、激光焦点的上下方向不正确,需要参加焦点定向测试,根据焦点的偏移量调整;
1. The upper and lower positions of laser focus are incorrect. The orientation of focus should be tested and adjusted according to the offset of focus.
2、激光输出功率不好,需要看看激光发生器的运转是否正常,如果是正常的话,,然后考察激光控制按钮的输出值是否正确,然后调整它;
2. The output power of the laser is not good. We need to check whether the operation of the laser generator is normal. If it is normal, we need to investigate whether the output value of the laser control button is correct, and then adjust it.
3、线切割的速度太慢了,你需要在控制过程中提高线路速度;
3. The cutting line speed is too slow, so it needs to increase the line speed when operating.
4、切割气体的纯度不好,需要供应高质量的切割气体;
4. The purity of cutting gas is not good, and high quality cutting gas should be supplied.
5、激光聚焦偏移,需要参加焦点定向测试,根据焦点的偏移量调整;
5. Laser focus offset needs focus orientation test, which is adjusted according to the offset of focus.
6、机床运行时间过长的不稳定性,现在就得关机重新启动。
6. The instability of the machine tool when it runs too long. It needs to be shut down and restarted at the moment.

转接电话
16650428746